1. While the vehicle is in park, touch Controls > Safety on the
touchscreen.
2. Navigate to Parental Controls.
3. Touch Off.
4.
Re-enter the PIN you created when enabling parental
controls.
NOTE: If you forget your Parental Controls PIN or wish to
change it, touch the Enter your Tesla Account credentials
link on your vehicle touchscreen and then follow the
instructions. You cannot disable parental controls from
your mobile device.
PIN to Drive
For an added layer of security, prevent Model Y from being
driven until a 4-digit PIN (Personal Identification Number) is
entered. To enable this setting, touch
Controls > Safety > PIN
to Drive and follow the on-screen prompts to create a driving
PIN.
When enabled, in addition to entering the 4-digit driving PIN
to drive, you must also use it to enter Valet mode for the first
time and create the 4-digit valet PIN to enter and exit Valet
mode. In Valet mode, Model Y can be driven without the
need for the valet to enter a driving PIN. The
PIN to Drive
setting is disabled whenever Valet mode is active.
If you forget your driving PIN, touch the link to enter your
Tesla login credentials on the PIN to Drive popup, then follow
the instructions on the touchscreen.
NOTE: In the unlikely event that your touchscreen is
unresponsive, you may be unable to enter the PIN. In this
case, first try to restart the touchscreen (see
Restarting the
Touchscreen on page 9). If the touchscreen is still
unresponsive, you can still bypass PIN to Drive by turning on
Keyless Driving in the Tesla mobile app.
Glovebox PIN
Protect the contents in your glovebox with a 4-digit PIN (not
related to PIN to Drive). To enable, touch Controls > Safety >
Glovebox PIN and follow the directions on the touchscreen.
When enabled, you are prompted to enter the PIN to open
the glovebox. Select the toggle to disable and then enter the
PIN to remove this added security protection.
If you forget your glovebox PIN, reset it by entering your
Tesla login credentials, then follow the directions on the
touchscreen.
NOTE: Using a Glovebox PIN allows the glovebox to be
opened even when Model Y is in Valet mode.
Speed Limit Mode
Speed Limit Mode allows you to limit acceleration and
maximum driving speed to a chosen value between
80 and
193 km/h. The first time you use this feature, you must create
a 4-digit PIN that you must use to enable and disable Speed
Limit Mode. When enabled and the driving speed approaches
within approximately 5 km/h of the maximum speed, a chime
sounds, the
touchscreen displays a message, and Model Y
sends a notification to the mobile app. You can also touch
Security > Speed Limit Mode to enable from the Tesla mobile
app. To enable Speed Limit Mode:
1. Ensure Model Y is in Park.
2.
Touch Controls > Safety > Speed Limit Mode on the
touchscreen.
3.
Select the maximum driving speed.
4.
Drag the slider to the On position.
5.
Enter the 4-digit PIN that you want to use to enable and
disable Speed Limit Mode.
NOTE: If you forget the PIN, you can disable Speed Limit
Mode by entering login credentials for your Tesla account.
NOTE: Off-Road Assist cannot be used if Speed Limit Mode is
already enabled.
NOTE: While Speed Limit Mode is enabled, the acceleration
setting automatically sets to Chill.
WARNING: Driving downhill can increase driving speed
and cause Model Y to exceed your chosen maximum
speed.
WARNING: Speed Limit Mode is not a replacement for
good judgment, driver training, and the need to closely
monitor speed limits and driving conditions. Accidents
occur at any speed and it is your responsibility to drive
safely.
Clear Browser Data
You can clear your vehicle's browser data (like you would on a
computer or smartphone) by navigating to Controls > Service
> Clear Browser Data. This is useful for many situations, such
erasing settings or searches from another driver.
Check the boxes on the touchscreen popup to exclude
bookmarks and/or history for your convenience.
Safety & Security Settings
127Dashcam, Sentry, and Security
To Next Page
Loading...
