4.
Connect the pigtail connector to the vehicle wiring
connector.
WARNING: Towing increases your stopping distance,
even when the trailer is equipped with its own braking
system. When towing, increase your following distance
and avoid situations that could potentially cause heavy
braking. Failure to do so can cause a collision.
WARNING: Observe all regulations and legal
requirements in your regional and national jurisdictions
that apply specifically to trailer towing and brake
requirements. Many regions require a breakaway
switch, located on the tongue of the trailer, to activate
the trailer brakes in the event that the trailer separates
from the vehicle. Failure to comply with regulations can
compromise your safety.
WARNING: Follow the instructions provided by the
trailer brake manufacturer to ensure that trailer brakes
are properly installed, adjusted, and maintained. Tesla
is not responsible for damages caused by incorrect
installation of trailer braking systems.
Parking with a Trailer
Whenever possible, avoid parking on a grade. However, if
parking on a grade is absolutely necessary, place wheel
chocks under the trailer wheels. Consider having someone
help you with these steps:
1.
One person presses and holds the brake pedal.
2.
A second person places the wheel chocks under the
wheels on the downgrade side of the vehicle's tires.
3.
When the chocks are in place, release the brake pedal and
ensure the chocks hold the weight of the vehicle and
trailer.
NOTE:
When testing chocks, ensure that Vehicle Hold
(see Vehicle Hold on page 86) is not engaged. If Vehicle
Hold is braking Model Y, the Vehicle Hold indicator light
displays on the touchscreen. To disengage Vehicle Hold,
press and release the brake pedal.
4.
Place the vehicle in Park.
WARNING:
If parking on a grade is necessary, always
ensure that all trailer wheels have been securely
chocked. Failure to do so can result in serious damage
or injury.
Trailer Sway Mitigation
When trailer sway is detected, the electronic stability control
system attempts to apply the appropriate amount of braking
to minimize trailer sway. The touchscreen briefly displays the
traction control system indicator. Pressing the brake pedal
when the system is actively braking to mitigate trailer sway
does not cancel this automatic braking.
Attaching and Removing the Ball Mount
The Model Y towing package does not include a ball mount.
You must purchase a ball mount suitable for the type of trailer
you are towing. The Model Y hitch receiver supports a ball
mount with a length of up to
22 cmand a rise of up to 2 cm.
Do not use any type of drop ball mount that does not meet
these requirements.
To attach a ball mount:
1.
Model Y has 2 push clips that secure the dust cover to the
vehicle. Use a thin object, such as a flat screwdriver, to
twist and pry the clips open. Remove the dust cover and
store it in a safe location.
Towing and Accessories
97Driving
To Next Page
Loading...
