FCC and ISED Certification
Component Manufacturer Model
Operating Frequency
(MHz)
FCC ID IC ID
B-Pillar endpoint Tesla 1783148 13.56, 2400-2483.5,
6000-8500
2AEIM-1783148 20098-1783148
Interior endpoint Tesla 1815669 2400-2483.5,
6000-8500
2AEIM-1815669 20098-1815669
Stardust Endpoint Tesla 2005551
2400-2483.5,
6000-8500,
312-315 (Receive only)
2AEIM-1752108 20098-1752108
TPMS Tesla 1472547G 2400-2483.5 2AEIM-1472547G 20098-1472547G
Glove Box BT USB
Module
Tesla 1776863 2400-2483.5 2AEIM-1776863 2AEIM-1776863
Cabin radar (if
equipped)*
Tesla 1616631 60000-64000 2AEIM-1616631 20098-1616631
Homelink (if
equipped)
Gentex ADHL5C 286-440 NZLADHL5C 4112A-ADHL5C
TCU Tesla 1763104 -- XMR2024AG555QGL
XMR202401AF68E
10224A-024AG555QGL
10224A-202401AF68E
TCU 4G Tesla 1727111 -- XMR2020AG525RGL
XMR202303AF51Y
10224A-2020AG525R
10224A-202201AF51Y
Wireless phone
charger
Tesla WC5 13.56 MHz, 127.72 KHz 2AEIM-WC5 20098-WC5
* The cabin radar is restricted to factory installation.
The devices listed above comply with Part 15 of the FCC rules and Industry Canada's license-exempt RSS Standard(s) and EU
Directive 2014/53/EU.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference; and
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by Tesla could void your authority to operate the equipment.
Radio Frequency Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician to help.
Certification Conformity
279Consumer Information
To Next Page
Loading...
