NOTE: You can also perform a factory reset to erase your
HomeLink settings, along with all other personal data (saved
addresses, music favorites, imported contacts, etc.). See
Erasing Personal Data with a Factory Reset on page 10.
NOTE: For security reasons, delete your HomeLink devices if
you sell your Model Y.
Troubleshooting HomeLink
Standard Mode
In Standard Mode, Model Y records the RF signal from your
HomeLink device's remote control. The touchscreen
instructs you to stand in front of the vehicle, point the
device's remote control at the front bumper, and press and
hold the button until the headlights flash. When the
headlights flash,
Model Y has learned the remote control and
you can touch Continue on the touchscreen. If the headlights
do not flash:
•
Check the batteries in the remote control. It is a good idea
to replace the batteries before you start programming.
• Ensure you are standing in front of Model Y with the
device's remote control positioned within
five cm of the
Tesla emblem.
• Press and hold the button on your device's remote control
until the headlights flash. In some cases you must hold the
button on the remote control for up to three minutes.
NOTE: Some HomeLink remote controls require multiple
short presses (approximately one second each press)
instead of one long duration press. If you are unsuccessful
after multiple attempts of using long presses, try repeated
presses of one second each.
D-Mode and UR-Mode
In D-Mode and UR-Mode, the device’s receiver learns Model
Y. The touchscreen instructs you to press the "Learn" button
(may also be called "Program" or "Smart") on the device's
receiver. If this does not work, refer to the following
guidelines:
•
Park Model Y with its bumper as close as possible to the
garage door, gate, etc. that you are trying to program.
•
Make sure you are pressing the receiver's Learn/Program/
Smart button. For instructions on how to put the receiver
into learning mode, refer to the product details provided
with your RF device that you are trying to program.
•
If you see a screen called "Train the receiver" while
programming the device, remember that this is a time-
sensitive step. After pressing the Learn/Program/Smart
button on the device's remote control or receiver, you only
have approximately 30 seconds to return to your vehicle,
press
Continue, then press the trained HomeLink device
name twice. Consider having someone assist you with this
step.
•
Most devices stay in learning mode for only three to five
minutes. Immediately after pressing the device's Learn/
Program/Smart button, follow the instructions displayed
on the vehicle's touchscreen.
For additional assistance or compatibility questions, contact
HomeLink (www.homelink.com or call 1-800-355-3515).
Smart Garage
65Connectivity
To Next Page
Loading...
