WARNING: Do not use ISOFIX/i-Size anchors with
child restraint system or booster seats that have an
integral safety belt where the combined weight of the
child plus the child restraint system exceeds 33 kg.
Safety Leg
All passenger seats Model Y support the use of a child
restraint system with a safety leg. If the child restraint system
is equipped with a leg, extend the leg as described in the
instructions provided by the manufacturer of the child
restraint system.
Attaching Upper Tether Straps
If an upper tether strap is provided, attach its hook to the
anchor point located behind the seat.
WARNING: Tighten upper tether straps according to
the instructions provided by the manufacturer of the
child safety seat.
WARNING: USE ONLY SEAT BELT RETAINED CHILD
SAFETY SEATS IN THE CENTER SEATING POSITION.
Make sure the hook is fully seated on the anchor point.
For dual-strap tethers in the outboard seating positions,
position a strap on each side of the head support.
For single-strap tethers in the outboard seating positions,
run the strap over the outside-facing side of the head
support (same side of the head support as the seat belt
retraction mechanism).
If routing the strap over the outside-facing side of the head
support is not possible (such as there is not enough slack in
the strap), raise the head support and (see Head Supports on
page 37)route the strap under the head support.
Child Safety Seats
48 MODEL Y Owner's Manual
To Next Page
Loading...
