HYDRAULIC PULLER-TENSIONER PT1250
Manual: MI-PT1250-050-01-IT Date: 06.11.2017 Author: AT Page: 10 of 69
3.11 USE NOT ALLOWED
The machine must not be used:
a. for lifting persons and/or goods
b. in closed/unventilated sites or, however, not sufficiently airy (tunnel or similar)
c. in sites with presence of gas that can be easily set on fire or explosives
d. in sites with presence of explosive materials
e. on aircraft, crafts, floating platforms and similar
f. for structure demolition, shafts felling or similar
g. for pulling flexible elements that can be highly lengthening, which allow elastic power accumulation
h. with ropes or joints having a bigger diameter than the one specified in present manual
i. when engine is off and bull-wheels are moving
j. with inhibited and broken safety devices installed on the machine
k. when winding on the bull-wheels ropes and/or conductors having a smaller diameter as a succession
of ropes and/or conductors having a bigger diameter for handling trucks or other moving equipment.
ATTENTION
is not allowed to install on board radio equipment. These could create electronic
equipment malfunctions, putting the personnel at serious risk.
3.12 RESPONSIBILITY
The use of the machine for scopes different from those foreseen, even if not well described in this
manual, has to be considered extremely dangerous and then forbidden.
ATTENTION
The non-respect of the prescribed restrains causes a situation of improper use for
technical and persons safety purposes and relieve the manufacturer from any
responsibility, civil or penal, in case of accidents to persons or damages to things,
causing the loss of warranty.
The manufacturer responsibility declines even when one of the following situations happens:
a. for the consequences caused by tampering and/or modifications carried out without the
manufacturer’s written acceptance (in this case the operator becomes the manufacturer with
relevant obligations and responsibilities, both civil and penal)
b. for the use of not original spare parts
c. or bad maintenance
d. for the use with disconnected safety devices
e. for the connection to machine and/or plans not produced and not directly authorized by the
manufacturer in a written acceptance.
To Next Page
Loading...
