Tesmec PT1250 - Connection the Remote Control

HYDRAULIC PULLER-TENSIONER PT1250
Manual: MI-PT1250-050-01-IT Date: 06.11.2017 Author: AT Page: 22 of 69
Connection the remote control
The main control of the machine is on the remote control. The machine is always set to connect the
remote control.
It will be possible to see the status of the connection, between the state of the icons in the main control
panel and on the transmitter remote control.
Remote control
CONNECTED
Remote control
DICONNECTED
Remote control
OFF
In the follow step, it is described the procedure to connect the radio remote control on the machine:
WARNING
Remember to connect or disconnect the radio remote control only when the
bull
-
wheel
machine are stationary
.
1. Check the status of the joystick position of the remote control. It’ll be on neutral position (close negative
brake of bull-wheel)
INFORMATION
It will impossible to connect the remote control still the joystick are on neutral
position