HYDRAULIC PULLER-TENSIONER PT1250
Manual: MI-PT1250-050-01-IT Date: 06.11.2017 Author: AT Page: 53 of 69
6.1.1 MACHINES SET-UP
Before use, the machines must be set up to be used in connection by assigning the correct identification
numbers.
When machines are connected, the machine with the highest reference number is the MASTER
machine, while the lower number machines are all SLAVE machines.
Through the MASTER machine it is possible to move and control all other machines.
Between the dedicate button allows you to reach the menu dedicated to the machine
connection: through this menu you can set the machine number and connect the machine to the other
machines by passing commands from one another.
1- Machine number selection: The SLAVE machine will have a lower value than the MASTER. The
MASTER machine will always have a larger number of SLAVE;
2- Activation Connection: performs the passage of the SLAVE machine commands to the nearest
SLAVE machine or to the MASTER;
3- Status of single machine: Allow to check the status of the single machine;
4- Status about all machine: Allow to check the status about all machine connected;
1
2
4
3
To Next Page
Loading...
