Tesmec PT1250 - Diesel Engine Control Parameters; Working Machine Parameters

HYDRAULIC PULLER-TENSIONER PT1250
Manual: MI-PT1250-050-01-IT Date: 06.11.2017 Author: AT Page: 20 of 69
You can switch from page to page, by using the appropriate button placed on the radio control.
Pull control and machine reel elevator pressure
page in PULLER configuration
This page allows the operator to control the pull
value on the machine and set the desired pull
value
Puller – XXX KN = CURRENT Pull value
8…12 KN = SET Pull value
RW – XXX bar = Reel elevator circuit pressure
value.
Pull control and machine reel elevator pressure
page in TENSIONER configuration
This page allows the operator to control the pull
value on the machine and set the desired pull
value
Tensioner – XXX KN = CURRENT Pull value
8…12 KN = SET Pull value
RW – XXX bar = Reel elevator circuit pressure
value.
Note: The transition between PULLER and TENSIONER is displayed automatically.
Working machine parameters
This page lets you control the speed of stringing of
conductor and the strung meters of rope or wire.
Diesel engine control parameters
This page allows you to control the speed and the
oil temperature of the diesel engine.