LODIV_BUF_CURRENT_TX[1:0]
Adjusts current TX LO buffer (input to PA). The value to use in
this field is given by the
Selects PA power setting. This value is an index to the
In OOK mode, this selects the PATABLE index to
use when transmitting a ‘1’. PATA
BLE index zero is used in
OOK when transmitting a ‘0’.
Frequency synthesizer calibration configuration
r before calibration is given by the
Disable charge pump calibration stage when 0
Frequency synthesizer calibratio
defining the charge pump output current, on an exponential scale:
Fast frequency hopping without calibration for each hop can be done
by calibrating upfront for each frequency and saving the resu
FSCAL3, FSCAL2 and FSCAL1 register values. Between each
frequency hop, calibration can be replaced by writing the FSCAL3,
FSCAL2 and FSCAL1 register values corresponding to the next RF
Frequency Synthesizer Calibration
Frequency synthesizer calibration result register. VCO c
calibration result and override value
pping without calibration for each hop can be done
by calibrating upfront for each frequency and saving the resulting
FSCAL3, FSCAL2 and FSCAL1 register values. Between each
frequency hop, calibration can be replaced by writing the FSCAL3,
1 register values corresponding to the next RF
To Next Page
Loading...
Need help?
General
