Analog Temperature Sensor
The characteristics of the analog temperature sensor
below. Note that it is necessary to write 0xBF to the
register to use the analog
temperature sensor in the IDLE state.
point calibration at room temperature
The indicated minimum and maximum error with 1
point calibration is based on
typical process parameters
C if nothing else stated.
For up to 4 mA output current
For up to 4 mA output current
When the power supply complies with the requirements in
Reset functionality is guaranteed. Otherwise, the chip should be assumed to have
strobe over the SPI interface. See Section
From 0 V until reaching 1.8 V