Tables 7-3
8307TABL.DOC TI-83 international English Bob Fedorisko Revised: 02/19/01 12:26 PM Printed: 02/19/01 1:36
PM Page 3 of 6
To display the
TABLE SETUP
screen, press
y
[
TBLSET
].
TblStart (table start) defines the initial value for the
independent variable.
TblStart applies only when the
independent variable is generated automatically (when
Indpnt: Auto is selected).
@
Tbl
(table step) defines the increment for the independent
variable.
Note:
In
Seq
mode, both
TblStart
and
@
Tbl
must be integers.
Selections Table Characteristics
Indpnt: Auto
Depend: Auto
Values are displayed automatically in both
the independent-variable column and in all
dependent-variable columns.
Indpnt: Ask
Depend: Auto
The table is empty; when you enter a value
for the independent variable, all
correspondin
dependent-variable values
are calculated and displayed automatically.
Indpnt: Auto
Depend: Ask
Values are displayed automatically for the
independent variable; to
enerate a value
for a dependent variable, move the cursor
to that cell and press
Í
.
Indpnt: Ask
Depend: Ask
The table is empty; enter values for the
independent variable; to
enerate a value
for a dependent variable, move the cursor
to that cell and press
Í
.
To store a value to
TblStart,
@
Tbl
, or Tbl
Z
nput from the
home screen or a program, select the variable name from
the
VARS TABLE
secondary menu. Tbl
Z
nput is a list of
independent-variable values in the current table.
When you press
y
[
TBLSET
] in the program editor, you
can select
IndpntAuto, IndpntAsk, DependAuto, and
DependAsk.
Setting Up the Table
TABLE SETUP
Screen
TblStart,
@
Tbl
Indpnt: Auto,
Indpnt: Ask,
Depend: Auto,
Depend: Ask
Setting Up the
Table from the
Home Screen or
a Program
To Next Page
Loading...
Need help?
General
