Split Screen 9-3
8309SPLT.DOC TI-83 international English Bob Fedorisko Revised: 02/19/01 12:31 PM Printed: 02/19/01 1:36
PM Page 3 of 6
To set a split-screen mode, press
z
, and then move the
cursor to the bottom line of the mode screen.
•
Select
Horiz (horizontal) to display the graph screen and
another screen split horizontally.
•
Select
G
.
T (graph-table) to display the graph screen and
table screen split vertically.
$$
The split screen is activated when you press any key that
applies to either half of the split screen.
Some screens are never displayed as split screens. For
example, if you press
z
in
Horiz or G
.
T mode, the mode
screen is displayed as a full screen. If you then press a key
that displays either half of a split screen, such as
r
,
the split screen returns.
When you press a key or key combination in either
Horiz or
G
.
T mode, the cursor is placed in the half of the display for
which that key applies. For example, if you press
r
,
the cursor is placed in the half in which the graph is
displayed. If you press
y
[
TABLE
], the cursor is placed in
the half in which the table is displayed.
The TI
-
83 will remain in split-screen mode until you
change back to
Full screen mode.
Using Split Screen
Setting a Split-
Screen Mode
To Next Page
Loading...
Need help?
General
