Texas Instruments TI-83 Guide Book

12-34 Statistics
8312STAT.DOC TI-83 international English Bob Fedorisko Revised: 02/19/01 12:42 PM Printed: 02/19/01 1:37
PM Page 34 of 38
To define a plot, follow these steps.
1. Press
y
[
STAT PLOT
]. The
STAT PLOTS
menu is
displayed with the current plot definitions.
2. Select the plot you want to use. The stat plot editor is
displayed for the plot you selected.
3. Press
Í
to select On if you want to plot the
statistical data immediately. The definition is stored
whether you select
On or Off.
4. Select the type of plot. Each type prompts for the
options checked in this table.
Plot Type
XList YList Mark Freq
Data
List
Data
Axis
"
Scatter
œœœ
Ó
xyLine
œœœ
Ò
Histogram
œœœœ
Õ
ModBoxplot
œœœ
Ö
Boxplot
œœœœ
Ô
NormProbPlot
œœœ
5. Enter list names or select options for the plot type.
•
Xlist (list name containing independent data)
•
Ylist (list name containing dependent data)
•
Mark (
›
or + or
¦
)
•
Freq (frequency list for Xlist elements; default is 1)
•
Data List (list name for NormProbPlot)
•
Data Axis (axis on which to plot Data List)
Defining the
Plots

Texas Instruments TI-83 Specifications

General

Programming	TI-BASIC
Processor	Zilog Z80, 6 MHz
Weight	7.4 oz (210 g)
Display	96x64 pixels, monochrome LCD
Power Source	4 AAA batteries, 1 CR1616 or CR1620 for backup
Memory	32 KB RAM
Connectivity	2.5mm I/O port for linking with other TI calculators