Texas Instruments TI-83 - Page 301

Programming 16-3
8316PROG.DOC TI-83 international English Bob Fedorisko Revised: 02/19/01 1:23 PM Printed: 02/19/01 1:39
PM Page 3 of 22
5. Press
 ~
3 to select 3:Disp from the
PRGM I/O
menu. Disp is pasted to the
command line. Press
y
[
A.LOCK
]
ããä
[
V
]
[
O
] [
L
] [
U
] [
M
] [
E
][
'
] [
I
] [
S
]
ããä
ƒ ¢
ƒ
[
V
]
Í
to set up the program to
display the text
VOLUME IS on one line and
the calculated value of
V on the next.
6. Press
y
[
QUIT
] to display the home
screen.
7. Press

to display the
PRGM EXEC
menu. The items on this menu are the
names of stored programs.
8. Press
Í
to paste prgmCYLINDER to the
current cursor location. (If
CYLINDER is
not item
1 on your
PRGM EXEC
menu,
move the cursor to
CYLINDER before you
press
Í
.)
9. Press
Í
to execute the program. Enter
1.5 for the radius, and then press
Í
.
Enter
3 for the height, and then press
Í
. The text
VOLUME IS, the value of V,
and
Done are displayed.
Repeat steps 7 through 9 and enter
different values for
R and H.