16-12 Programming
8316PROG.DOC TI-83 international English Bob Fedorisko Revised: 02/19/01 1:23 PM Printed: 02/19/01 1:39
PM Page 12 of 22
End identifies the end of a group of
commands
. You must
include an
End instruction at the end of each For(, While, or
Repeat loop. Also, you must paste an End instruction at the
end of each
If
.
Then group and each If
.
Then
.
Else group.
Pause suspends execution of the program so that you can
see answers or graphs. During the pause, the pause
indicator is on in the top-right corner. Press
Í
to
resume execution.
•
Pause without a
value
temporarily pauses the program.
If the DispGraph or Disp instruction has been executed,
the appropriate screen is displayed.
•
Pause with
value
displays
value
on the current home
screen.
value
can be scrolled.
Pause [
value
]
Program Output
End
Pause
To Next Page
Loading...
