Texas Instruments TI-83 Guide Book

Programming 16-21
8316PROG.DOC TI-83 international English Bob Fedorisko Revised: 02/19/01 1:23 PM Printed: 02/19/01 1:39
PM Page 21 of 22
GetCalc( gets the contents of
variable
on another TI
-
83 and
stores it to
variable
on the receiving TI
-
83.
variable
can be
a real or complex number, list element, list name, matrix
element, matrix name, string,
Y=
variable, graph database,
or picture.
GetCalc(
variable
)
Note:
GetCalc(
does not work between TI
.
82s and TI
-
83s.
Get( gets data from the Calculator-Based Laboratory
é
(CBL 2
é
, CBL
é
) System or Calculator-Based Ranger
é
(CBR
é
) and stores it to
variable
on the receiving TI
-
83.
variable
can be a real number, list element, list name,
matrix element, matrix name, string,
Y=
variable, graph
database, or picture.
Get(
variable
)
Note:
If you transfer a program that references the
Get(
command to
the TI
-
83 from a TI
.
82, the TI
-
83 will interpret it as the
Get(
described
above. Use
GetCalc(
to get data from another TI
-
83.
Send( sends the contents of
variable
to the CBL 2/CBL or
CBR. You cannot use it to send to another TI
-
83.
variable
can be a real number, list element, list name, matrix
element, matrix name, string,
Y=
variable, graph database,
or picture.
variable
can be a list of elements.
Send(
variable
)
Note:
This program gets sound data
and time in seconds from
CBL 2/CBL.
Note:
You can access
Get(
,
Send(
, and
GetCalc(
from the
CATALOG
to execute them from the home screen (Chapter 15).
GetCalc(
Get(, Send(

Texas Instruments TI-83 Specifications

General

Programming	TI-BASIC
Processor	Zilog Z80, 6 MHz
Weight	7.4 oz (210 g)
Display	96x64 pixels, monochrome LCD
Power Source	4 AAA batteries, 1 CR1616 or CR1620 for backup
Memory	32 KB RAM
Connectivity	2.5mm I/O port for linking with other TI calculators