Communication Link 19-7
8319LINK.DOC TI-83 Intl English, Chap 19 Bob Fedorisko Revised: 02/19/01 1:24 PM Printed: 02/19/01 1:40 PM
Page 7 of 10
After sending or receiving data, you can repeat the same
transmission to additional TI
-
83 units—from either the
sending unit or the receiving unit—without having to
reselect data to send. The current items remain selected.
Note:
You cannot repeat transmission if you selected All+ or All
.
.
To transmit to an additional TI
-
83, follow these steps.
1. Set the TI
-
83 to receive (page 19
.
5).
2. Do not select or deselect any new items to send. If you
select or deselect an item, all selections or deselections
from the previous transmission are cleared.
3. Disconnect the link cable from one TI
-
83 and connect it
to the additional TI
-
83.
4. Set the additional TI
-
83 to receive (page 19
.
5).
5. Press
y
[
LINK
] on the sending TI
-
83 to display the
LINK SEND
menu.
6. Select the menu item that you used for the last
transmission. The data from your last transmission is
still selected.
7. Press
~
to display the
LINK TRANSMIT
menu.
8. Confirm that the receiving unit is set to receive
(page 19
.
5).
9. Press
Í
to select
1:Transmit
and begin transmitting.
Transmitting
Items to an
Additional TI-83
To Next Page
Loading...
Need help?
General
