Texas Instruments TI-89 Titanium User Manual

Programming 559
Press ´ to stop program execution. A message is then displayed.
Where Is the Output Displayed?
Depending on the commands in the program, the TI-89 Titanium automatically displays
information on the applicable screen.
• Most output and input commands use the Program I/O screen. (Input commands
prompt the user to enter information.)
• Graph-related commands typically use the Graph screen.
After the program stops, the TI-89 Titanium shows the last screen that was displayed.
The Program I/O Screen
On the Program I/O screen, new output is displayed below any previous output (which
may have been displayed earlier in the same program or a different program). After a full
page of output, the previous output scrolls off the top of the screen.
• To display the program in the Program
Editor, press ¸. The cursor appears
at the command where the break
occurred.
• To cancel program execution, press N.

Texas Instruments TI-89 Titanium Specifications

General

Display Type	LCD
Display Resolution	160 x 100 pixels
CPU	Motorola 68000
CPU Speed	16 MHz
RAM	256 KB
Flash ROM	2.7 MB
Programming Language	TI-BASIC, Assembly
Power Source	4 AAA batteries
Connectivity	I/O port
Dimensions	7.5 x 3.5 x 1 inches