Programming 602
1. Position the cursor where you want to insert the setMode command.
3. Select a mode to display a menu of its valid settings.
4. Select a setting.
Getting Input from the User and Displaying Output
Although values can be built into a program (or stored to variables in advance), a
program can prompt the user to enter information while the program is running.
Likewise, a program can display information such as the result of a calculation.
F3 I/O Toolbar Menu
2. Press:
2 ˆ to display a list of modes.
Note: The Mode menu does not let you set
the
Current Folder mode. To set this
mode, use the
setFold command.
The correct syntax is
inserted into your program.
:setMode("Graph","FUNCTION")
To enter most of the commonly used
input/output commands, use the Program
Editor’s …
I/O toolbar menu.
To Next Page
Loading...
