Programming 595
You can then begin entering the commands that will be executed in the loop.
Note: A loop command marks the start of the loop. The corresponding End command
marks the end of the loop.
For...EndFor Loops
A
For...EndFor loop uses a counter to control the number of times the loop is repeated.
The syntax of the
For command is:
Note: The ending value can be less than the beginning value, but the increment must be
negative.
When you select a loop, the loop command
and its corresponding
End command are
inserted at the cursor location.
:For | Ê
:EndFor
Ê
If the loop requires
arguments, the cursor
is positioned after the
command.
For(variable
, begin, end [, increment])
Ê variable used as a counter
Ë counter value used the first time For is executed
Ì exits the loop when variable exceeds this value
Í added to the counter each subsequent time For is executed
ÊËÌ Í
To Next Page
Loading...
