Chapter 3: First Time Setup
Once the hardware is installed, physically connected to your network, and powered
on, you can configure the Thecus IP storage so that it is accessible to your network
users. There is one way to set up your Thecus IP storage: using the Thecus Smart
Utility(N2200/N0204) /Thecus Setup Wizard(N2200Plus/EVO,N4100EVO).
Follow the steps below for initial software setup.
Thecus Smart Utility (N0204/N2200)
The handy Thecus Smart Utility makes configuring N0204/N2200 a snap. To
configure the Thecus IP storage using the Smart Utility, perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Smart Utility should launch automatically. If not, please browse your
CD-ROM drive and double click on autorun.exe. Click “N0204/N2200 ”.
3. Select the N0204/N2200 that you like to configure. Press Next to continue.
4. First, please select System Installation Wizard.
To Next Page
Loading...
Need help?
General