Chapter 2: Hardware Installation
Overview
Your Thecus IP storage is designed for easy installation. To help you get started, the
following chapter will help you quickly get your Thecus IP storage up and running.
Please read it carefully to prevent damaging your unit during installation.
Before You Begin
Before you begin, be sure to take the following precautions:
1. Read and understand the Safety Warnings outlined in the beginning of the
manual.
2. If possible, wear an anti-static wrist strap during installation to prevent static
discharge from damaging the sensitive electronic components on the IP
storage.
3. Be careful not to use magnetized screwdrivers around the Thecus IP
storage‘s electronic components.
Hard Disk Installation
N0204:
The N0204 miniNAS supports two standard 2.5‖ Serial ATA (SATA) hard disks. To
install a hard disk into the N0204 miniNAS, follow the steps below:
1. Open 2.5‖ HDD tray from N0204 miniNAS, as the following chart.
To Next Page
Loading...
Need help?
General