Thecus N4100EVO - DHCP Server Configuration; (Only for N2200 PLUS;N2200 EVO;N4100 EVO); Lan2 Configuration

52
LAN2 (Only for N2200PLUS/EVO,N4100EVO)
LAN2 Configuration
The Thecus IP storage supports two Gigabit Ethernet ports for higher service
availability. To configure these ports, choose LAN2 from the System Network
menu, and the LAN2 Configuration screen appears. Press Apply to save your
changes.
LAN2 Configuration
Item
Description
MAC Address
Displays the MAC address of the LAN2 interface.
IP
Specifies the IP address of the LAN2 interface.
Netmask
Specifies the Network Mask of the LAN2 interface.
Link Detected
Specifies the LAN2 port link status.
Link Speed
Specifies the LAN2 port link speed.
DHCP Server Configuration
A DHCP server can be configured to assign IP addresses to devices connected to the
LAN2 port. To configure these ports, choose LAN2 from the System Network
menu.
DHCP Configuration
Item
Description
DHCP Server
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN2 interface.
Start IP
Specifies the starting IP address of the DHCP range.
End IP
Specifies the ending IP address of the DHCP range.
DNS Server
Displayed the DNS server IP address.
NOTE
The IP Segment of WAN/LAN1 and LAN2 should not overlap.
WARNING
The IP address of the LAN2 interface should not be in the range of the
Start IP address and End IP address.