Thecus Setup Wizard (N2200PLUS/EVO,N4100EVO)
The handy Thecus Setup Wizard makes configuring N2200PLUS/EVO,N4100EVO a
snap. To configure the N2200PLUS/EVO,N4100EVO using the Setup Wizard,
perform the following steps:
1. Insert the installation CD into your CD-ROM drive (the host PC must be
connected to the network).
2. The Setup Wizard should launch automatically. If not, please browse your
CD-ROM drive and double click on Setup.exe.
3. The Setup Wizard will start and automatically detect all Thecus storage
devices on your network. If none are found, please check your connection
and refer to Chapter 7: Troubleshooting for assistance.
4. Select the N2200PLUS/EVO,N4100EVO that you like to configure.
5. Login with the administrator account and password. The default account and
password are both āadminā.
To Next Page
Loading...
