N2200PLUS/EVO:
1. Plug your USB device into an available USB port on the Rear Panel.
2. Press the ―USB Copy Button”.
3. The N2200PLUS will start copying USB disks connected to the rear USB port.
The LCD will display the USB copy progress and result.
N4100EVO:
The USB Copy function enables you to copy files stored on USB devices such as USB
disks and digital cameras to the N4100EVO with a press of a button. To use USB
copy, follow the steps below:
1. Plug your USB device into an available USB port on the Front Panel.
2. In Display Mode, press the Enter ().
3. The LCD will display ―USB Copy?‖
4. Press Enter () and the N4100EVO will start copying USB disks connected to
the front USB port.
5. All of data will be copied into system folder named ―USBcopy‖.
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your Thecus IP
storage for use on your network. Setting up the Thecus IP storage typically follows
the five steps outlined below.
For more on how to use the Web Administration Interface, see
Chapter 4: Web Administration Interface.
To Next Page
Loading...
Need help?
General