Follow the steps below to upgrade your firmware:
1. Use the Browse button to find the firmware file.
2. Press Apply.
3. The beeper beeps and the Busy LED blinks until the upgrade is complete.
• Downgrading firmware is not permitted.
• The beeper only beeps if it is enabled in the System Notification menu.
• Check Thecus website for the latest firmware release and release notes.
NOTE
This will lead to a catastrophic result that may render the system inoperable.
Do not turns off the system during the firmware upgrade process.
WARNING
UPS Setting
The N4100PRO can also support various uninterruptible power supply units via
either “Serial” or “USB” interface, providing extra data security and accessibility in
the case of a power failure.
From the Status menu, choose the UPS item and the UPS Setting screen appears.
Make any changes you wish, and press Apply to confirm changes.
See the following table for a detailed description of each item.
UPS Setting
Item Description
UPS Monitoring Enable or disable UPS monitoring.
Manufacturer Choose the UPS manufacturer from the dropdowns.
Model Choose the UPS model number from the
dropdowns.
Battery Status Current status of the UPS battery
Power Current status of the power being supplied to the
UPS
Seconds between power failure and
first notification
Delay between power failure and first notification in
seconds.
Seconds between subsequent power
failure notifications
Delay between subsequent notifications in seconds.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
