120
Chapter 3: System Administration
Uninterrupted Power Source3.9.2
From the External Devices menu, choose the Uninterrupted Power Source item and the UPS Setting
screen appears. Make any changes you wish, and press Apply to confirm changes.
See the following table for a detailed description of each item.
UPS Setting
Item
Description
UPS Monitoring Enable or disable UPS monitoring.
Remote UPS Monitoring Enable or disable Remote UPS monitoring.
Remote UPS IP Input the IP address of the NAS that the UPS device is connected to via USB or RS232.Input the
IP address of your network UPS.
Manufacturer Choose the UPS manufacturer from the dropdowns.
Model Choose the UPS model number from the dropdowns.
Battery Status Current status of the UPS battery
Power Current status of the power being supplied to the UPS
Seconds between power fail-
ure and first notification
Delay between power failure and first notification in seconds.
Seconds between subsequent
power failure notifications
Delay between subsequent notifications in seconds.
Shutdown the system when
the battery charge is less than
Amount of UPS battery remaining before system should auto-shutdown.
Apply Press Apply to save your changes.
To Next Page
Loading...
Need help?
General
