NAS Stacking 3.4.3
The Thecus IP storage’s capacity can be expanded even further using the stackable function. With it,
users can expand the capacity of their network storage systems up to 5 other stack target volumes
which are located in different systems. These can be stacked through single network access like SMB
or AFP acting as a share folder type.
From the Control Panel, the stackable feature is located under “Storage”. Please refer the figure below
for reference.
A. Add a Stack Target Volume
From the figure above, click Add to access the stackable target device configuration page. Please
refer to the figure below:
With the added stack target you can “Enable” or “Disable” the stack target now or later depending on
usage required.
To Next Page
Loading...
