Factory Default3.3.12
From the System Management category, choose the Factory Default item and the Reset to Factory
Default screen appears. Press Apply to reset Thecus IP storage to factory default settings.
Resetting to factory defaults will not erase the data stored in the hard
disks, but WILL revert all the settings to the factory default values
Power Management3.3.13
From the System Management category, choose Power Management item, and the Shutdown/Re-
boot System screen appears. Press Reboot to restart the system or Shutdown to turn the system off.
File System Check3.3.14
The File System Check allows you to perform a check on the integrity of your disks’ file system. Under
the System Management category, click File system Check and the File System Check prompt ap- system Check and the File System Check prompt ap-system Check and the File System Check prompt ap-em Check and the File System Check prompt ap-m Check and the File System Check prompt ap-
pears.
To perform a file system check, click Apply.
Once clicked, the following prompt will appear:
Click Yes to reboot the system.
Once the system has rebooted, you will be returned to the File System Check prompt. There you will
see the available RAID volumes to run the file system check. Check the desired RAID volumes and
click Next to proceed with the file system check. Click Reboot to reboot without running the check.
To Next Page
Loading...
Need help?
General
