Syslog Management3.3.6
Generates system log to be stored locally or remotely, it also can be chose to act as syslog server for
all other devices.
Information can be obtained in two ways: locally and remotely.
Conguration with syslog server:• Configuration with syslog client and •
target to store locally:
Conguration with syslog client and target to store remotely:•
See the following table for a detailed description of each item:
Syslog Management
Item Description
Syslog Daemon Enable/Disable syslog daemon.
Syslog service
If Server has been selected then associated syslog folder will be used to store all system logs from other
NAS devices which has assigned this system for syslog server as well as syslog of this server unit. It can be
seen from associated syslog folder with files “error”, “Information” and “warning”.
If client has been selected then “Local” or “Remotely” can be choose.
Target
Choose Local, all system logs will be stored in an associated syslog folder filled in from next filed. And the
syslog folder will have file “Associated log info” to store all system logs. If Remotely has been selected, a
syslog server is needed and an IP address is required.
Syslog folder
Select from a drop down share list, all of the system logs will be stored on it. This syslog folder is applied to
“syslog server” or “syslog client” with “local” selected.
Log Level The user can choose from 3 different levels. “All”, “Warning/Error” or “Error”.
Remote IP Address Input the syslog server IP address if choose to store syslog info remotely.
Date and Time: Setting system time 3.3.7
From the System Management category, choose the Date and Time item and the Date and Time
screen appears. Set the desired Date, Time, and Time Zone. You can also elect to synchronize the sys-
tem time on Thecus IP storage with an NTP (Network Time Protocol) Server.
To Next Page
Loading...
Need help?
General
