D. Stack Target ACL
If the stack target Public setting set to Yes, then the ACL button will be grayed out. However, if Public
setting is set to No, then the ACL button will be available for you to setup user access permissions for
the stack target.
The ACL settings will be exactly the same as the system folder that you may have setup previously.
E. Reconnect a Stack Target
This is used to enable stack target devices that may have been disconnected due to a power outage
or a disconnected network. When this happens, the Reconnect button will become available. To at-a disconnected network. When this happens, the Reconnect button will become available. To at-. When this happens, the Reconnect button will become available. To at- When this happens, the Reconnect button will become available. To at-, the Reconnect button will become available. To at-button will become available. To at-will become available. To at-become available. To at-available. To at-To at-
tempt to reconnect the stack target, click Reconnect.
To Next Page
Loading...
