Full Backup•
Click on full backup and the setup screen appear as below. Fill in the remote target IP (Destination)
and port (need to be changed only if this port is already in use).
If encryption is required then enable it. Please make sure the associated target server also has
encryption enabled.
Carry on with inputting valid remote target server account name and password.
After the settings are complete, please click on “Connection Test”. The source unit will try to connect
with the associated target system. If a connection can be built up successfully then “Connection
passed” will be prompted, otherwise “Failed” will appear.
Click “Next” and more setting will appear.
To Next Page
Loading...
