THERMACUT EX-TRAFIRE 125HD - Transport and positioning

EN - 14
5 Transport and positioning EX-TRAFIRE
®
125HD
5 Transport and positioning
WARNING
Risk of injury due to improper transport and installation
Improper transport and installation can cause the EX-TRAFIRE
®
125HD to
tip or fall over. This may result in serious injury.
• Wear your personal protective equipment.
• Ensure that all supply lines and cables do not encroach into the area in
which employees are working.
•Place the EX-TRAFIRE
®
125HD on a suitable surface (flat, solid, and dry)
on which it will not topple over, taking into account the max. tilt angle
of 15°.
• Note the weight of the EX-TRAFIRE
®
125HD when lifting it.
 4.2 Technical data on page EN-11
• Use an appropriate lifting tool with load handling equipment for
transporting and installing the EX-TRAFIRE
®
125HD.
• Avoid abrupt lifting and setting down.
• Do not lift the EX-TRAFIRE
®
125HD over individuals or other devices.
• Use the attachment points provided.
NOTICE
Risk of material damage due to improper transport and installation
Improper transport or installation can cause the EX-TRAFIRE
®
125HD to
tip or fall over. This can result in material damage and irreparable
damage.
• Protect the EX-TRAFIRE
®
125HD against weather conditions, such as
rain and direct sunlight.
• Protect the EX-TRAFIRE
®
125HD from spatter when cutting.
• Protect the EX-TRAFIRE
®
125HD from direct exposure to sparks when
grinding.
•Use the EX-TRAFIRE
®
125HD only in dry, clean, and well-ventilated
rooms.
• Maintain a minimum distance of 1 m from the wall when positioning
the EX-TRAFIRE
®
125HD to ensure that it has sufficient ventilation.
 When positioning the
EX-TRAFIRE
®
125HD, make sure that
the water separator's drain opening
is not covered.