THERMACUT EX-TRAFIRE 125HD - Consumables for standard machine cutting torch 85-125 A

EN - 48
19 FHT-EX
®
125TTM consumables for machine cutting torch EX-TRAFIRE
®
125HD
19.2 FHT-EX
®
125TTM consumables for standard
machine cutting torch 85–125 A
 If a torch height controller is used, a retaining cap with IHS (initial height
sensing) must be used.
Table 22 FHT-EX
®
125TTM consumables for standard machine cutting
torch 85–125 A
Item Part number Description
A See item no. 3 Swirl ring holder
B EX-6-404-021 Swirl ring 45–125 A
C EX-6-401-021 Electrode 45–125 A
part is only available in a 5 piece set,
including 1 swirl ring holder
D EX-6-409-021 Nozzle 85–125 A
E EX-6-415-021 Retaining cap 45–125 A
F EX-6-415-022 Retaining cap 45–125 A with IHS tab
G EX-6-421-021 Shield 85–125 A, machine
H EX-6-440-020 Nozzle, gouging
I EX-6-440-023 Shield, gouging, standard
J EX-6-440-024 Shield, gouging, high removal
A
Gouging
Shielded
BCD
H
FJ
I
E
F
G
E