THERMACUT EX-TRAFIRE 125HD - Default Chapter; Table of Contents

EN - 2
EX-TRAFIRE
®
125HD
Table of contents
1 Identification.............................................................. EN-5
1.1 Marking............................................................................................ EN-5
1.2 Identification plate ......................................................................... EN-5
1.3 Signs and symbols used................................................................ EN-5
1.4 Classification of the warnings....................................................... EN-6
2 Safety ......................................................................... EN-6
2.1 Designated use............................................................................... EN-6
2.2 Obligations of the operator.......................................................... EN-7
2.3 Warning and notice signs.............................................................. EN-7
2.4 Product-specific safety instructions.............................................. EN-7
2.5 Safety instructions for the electrical power supply .................... EN-8
2.6 Safety instructions for plasma cutting.......................................... EN-8
2.7 Personal protective equipment .................................................... EN-8
2.8 Emergency information................................................................. EN-8
3 Scope of delivery ....................................................... EN-9
4 Product description..................................................EN-10
4.1 Assembly and use ........................................................................ EN-10
4.2 Technical data............................................................................... EN-11
4.3 Technical data for cutting torches FHT-EX
®
125TTH and
FHT-EX
®
125TTM........................................................................... EN-12
5 Transport and positioning........................................EN-14
6 Setting up the power supply ...................................EN-15
6.1 Connecting to the gas supply..................................................... EN-15
6.2 Connecting the work lead........................................................... EN-15
6.3 Connecting the power supply cable ......................................... EN-15
6.4 Connecting the input power plug.............................................. EN-16
6.4.1 Connection to a generator (optional)........................................ EN-16
6.5 Connecting the cutting torch...................................................... EN-17
6.6 Connecting the CNC interface ................................................... EN-17
6.6.1 Setting the DIP switches.............................................................. EN-18
6.6.2 Enabling the external DC coil with an external power supply EN-19
6.6.3 Enabling the external AC coil with an external power supply EN-19
6.6.4 Enabling the industrially insulated module with an
external power supply................................................................. EN-20
6.7 Installing consumables for the hand and machine
cutting torches.............................................................................. EN-20
6.8 Aligning FHT-EX
®
125TTM machine cutting torch.................... EN-22
7 Operation of the power supply ...............................EN-23
7.1 LCD description............................................................................ EN-24
7.1.1 Setting the parameters................................................................ EN-24
7.1.2 Selecting the cutting mode......................................................... EN-25
7.1.3 Connecting the work lead with the work lead clamp.............. EN-25
7.2 Powering on the machine ........................................................... EN-26
7.3 Manual cutting process ............................................................... EN-26
7.4 Manual grid cutting and gouging process ............................... EN-26
7.5 Cutting........................................................................................... EN-27
7.6 Piercing.......................................................................................... EN-28
7.7 Gouging ........................................................................................ EN-29