THERMACUT EX-TRAFIRE 125HD - Obligations of the operator; Warning and notice signs; Product-specific safety instructions

EX-TRAFIRE
®
125HD 2Safety
EN - 7
2.2 Obligations of the operator
 Ensure that only qualified personnel are permitted to work on the
EX-TRAFIRE
®
125HD.
Authorized personnel are:
— those who are familiar with the basic regulations on occupational
safety and accident prevention;
— those who have been instructed on how to handle the
EX-TRAFIRE
®
125HD;
— those who have read and understood these operating instructions;
— those who have been trained accordingly;
— those who are able to recognize possible risks because of their
special training, knowledge and experience.
 Keep untrained persons out of the work area.
 Each time the EX-TRAFIRE
®
125HD’s cover plates are opened, have
Thermacut
®
or another authorized specialist perform a safety inspection
in accordance with DIN IEC 60974 Part 4: “Periodic inspection and
testing”.
The EX-TRAFIRE
®
125HD can produce electromagnetic fields that could
impact the proper function of cardiac pacemakers and implanted
defibrillators.
 Do not use the EX-TRAFIRE
®
125HD if you have a pacemaker or an
implanted defibrillator.
This Class A cutting device is not intended for use in residential areas with
a public low-voltage power supply system. It can potentially be difficult to
guarantee electromagnetic compatibility in these areas due to both
conducted and emitted interference.
 The EX-TRAFIRE
®
125HD may be used only in industrial zones according
to DIN EN 61000-6-3.
2.3 Warning and notice signs
The following warning, notice and mandatory signs can be found on the
product:
These markings must always be legible. They may not be covered,
obscured, painted over, or removed.
2.4 Product-specific safety instructions
 Do not use or store the EX-TRAFIRE
®
125HD outdoors where it is wet.
 Do not operate the EX-TRAFIRE
®
125HD if the housing is open.
 Read and observe the operating instructions.