TSC 800 TRANSFER SWITCH CONTROLLER
PM 049 REV 9 06/04/24 Thomson Technology
5.6.
UTILITY SUPPLY MENU 26
5.7.
GENERATOR SUPPLY MENU 27
5.8.
STATS MENU 28
6. OPERATING INSTRUCTIONS 29
6.1.
AUTOMATIC SEQUENCE OF OPERATION 29
6.1.1.
NORMAL SEQUENCE OF OPERATION (OPEN TRANSITION TRANSFER) 29
6.1.2.
NORMAL SEQUENCE OF OPERATION (CLOSED TRANSITION TRANSFER) 30
6.1.3.
TEST MODE SEQUENCE OF OPERATION 31
6.1.4.
ABNORMAL SEQUENCE OF OPERATION 33
6.2.
LCD DISPLAY OPERATION 33
6.4.1
OPERATOR INITIATED UTILITY POWER FAIL SIMULATION (LOAD TEST) 35
6.4.2
AUTOMATIC PLANT EXERCISE TEST 36
6.4.3
FOUR FUNCTION REMOTE TEST (FTS4 OPTION) 36
6.5
TRANSFER FAIL FAULT RESET 38
6.6
LAMP TEST 38
6.7
TIMER BYPASS 38
6.8
MANUAL UTILITY RE-TRANSFER 39
6.9
SERVICE ENTRANCE ATS MODE 39
6.10
PHASE BALANCE PROTECTION ALARM 39
7. PROGRAMMING INSTRUCTIONS 41
7.1.
PASSWORDS 41
7.1.1.
READ ONLY MODE 41
7.1.2.
READ / WRITE MODE 41
7.1.3.
MASTER READ / WRITE MODE 41
7.2.
EXERCISE TIMER 42
7.2.1.
SYSTEM TIME ROLLOVER 43
7.2.2.
AUTO TEST START DAY/WEEK NUMBER 43
7.2.3.
AUTO TEST START HOUR 43
7.2.4.
AUTO TEST START MINUTE 43
7.2.5.
AUTO TEST STOP DAY/WEEK NUMBER 43
7.2.6.
AUTO TEST STOP HOUR 44
7.2.7.
AUTO TEST STOP MINUTE 44
7.2.8.
AUTO TEST MODE 44
7.3.
SYSTEM CONFIGURATION 44
7.3.1.
FIRMWARE VERSION 44
7.3.2.
ATS MODE MENU PASSWORD (PW) 45
7.3.3.
UTILITY FAIL CALLOUT 45
7.3.4.
LOAD ON GENERATOR CALLOUT 45
7.3.5.
TRANSFER FAIL CALLOUT 46
7.3.6.
AUTO TEST CALLOUT 46
7.3.7.
MAN TEST CALLOUT 46
7.3.8.
SWITCH NOT IN AUTO CALLOUT 46
To Next Page
Loading...
Need help?
General
