TSC 800 TRANSFER SWITCH CONTROLLER
PM 049 REV 9 06/04/24 Thomson Technology
2
1.2. GENERAL DESCRIPTION
The TSC 800 controller utilizes microprocessor-based design technology, which provides high
accuracy for all voltage sensing and timing functions. The TSC 800 is factory configured to
control all the operational functions and display features of the automatic transfer switch. All
features of the TSC 800 are fully programmable from the front panel LCD display and are
security password protected. The LCD display screen prompts are in plain English, providing
a user-friendly operator interface with many display options available. The microprocessor
design provides many standard features, which were previously only available as add-on
optional features.
A summary of new and enhanced features provided in SOFTWARE VERSION 2.0 Release is
as follows:
On Board Data Logging
o Total Number of Transfers
o Total Number of Transfers due to source failure
o Number of Hours Controller is energized
o Number of Hours Load is on Utility
o Number of Hours Load is on Generator
Timer Bypass Function
o Faceplate Key Press Can Bypass Various Displayed Control Timer
o Timer is Automatically Reset on Next Sequence
o Operator Can Initiate Immediate Actions When Desired
Phase Balance Sensing
o Ensures Load is Fed from Balanced Source
o Programmable Voltage Tolerance Settings
o Phase Balance on Both Utility & Generator Sources
Automatic or Manual Retransfer to Utility
o User Programmable Retransfer Modes in Software
o Manual Retransfer Requires Operator Key Press to Initiate Retransfer to Utility
once Available
o Manual Re-transfer is Automatically Bypassed on Generator Failure
Auto Test Timer
o Transfer Switch Allows User to Initiate an “Auto Test” Mode and after a Pre-
programmed Time Delay, ATS Retransfers Back to Utility
o 15 – 240 Min. User Programmable Timer in Software
To Next Page
Loading...
Need help?
General
