© 2020 Thorlabs GmbH22
DC2200
3.4.1 Installing Software
Note
Do not connect the DC2200 to the PC prior to software installation!
Attention
Exit all running applications on your PC as the installer may require a reboot of your PC
during installation!
Thorlabs is breaking new ground in saving our environment. We decided to refrain from ship-
ping an installation CD ROM and to offer a download of the software from our website instead.
As an additional advantage to this distribution method, the most recent version of the software
will always be available online.
The DC2200 software package can be found easily on the website. Download it and unzip the
archive, making sure to note the target location.
Start the installation by double clicking the setup.exe file:
The installer verifies if NI-VISA™ Runtime V 5.1.1 or later software is installed on your com-
puter. If so, the installer skips the NI Software installation and continues with the DC2200 soft-
ware installation . For completeness, below the NI software installation steps are listed.
25
To Next Page
Loading...
