© 2020 Thorlabs GmbH
5 Maintenance and Service
59
5.2 Firmware Update
In order to update the DC2200 firmware, a newer firmware image (file extension *.dfu) and the
Thorlabs DFU Wizard are required.
The DFU Wizard is a software tool to upload a firmware image to the DC2200. You will find it
installed to your computer after downloading and installing the DC2200 Software package from
our web site. Here (tab "Firmware") the up-to-date firmware image can be found as well.
Please download it and remember the location on your computer where you saved it to.
1. Switch on your DC2200, select the SYSTem Settings menu and check the box "Enable Firm-
ware Update":
2. Connect your DC2200 to the computer using the supplied USB cable. The computer recog-
nizes the connected device and installs the required driver software:
3. Start the DFU Wizard and follow the steps as shown in the screen shots below:
To Next Page
Loading...
Need help?
General
