© 2020 Thorlabs GmbH6
DC2200
Attention
Mobile telephones, cellular phones or other radio transmitters are not to be used within the
range of three meters of this unit since the electromagnetic field intensity may then exceed the
maximum allowed disturbance values according to IEC 61326-1.
This product has been tested and found to comply with the limits according to IEC 61326-1 for
using connection cables shorter than 3 meters (9.8 feet).
1.2 Ordering Codes and Accessories
High-Power LED Current Controller
Connection Cable for custom LED - terminal LED1 (one end open wires, in-
cluded)
Connection Cable for custom LED - terminal LED2 (one end open wires, in-
cluded)
Thorlabs Fiber Coupled LED
1.3 Requirements
These are the requirements for the PC intended to be used for remote operation of the
DC2200.
Hardware Requirements
CPU: 1 GHz or higher
RAM: 256 MB
Graphic card Min. 32 MB memory
Hard disc Min 100 MB free storage space
Interface free USB 2.0 port, USB cable according the USB 2.0 specification
Software Requirements
The DC2200 software is compatible with the following operating systems:
· Windows
®
XP (32-bit) SP3
· Windows
®
Vista (32-bit, 64-bit)
· Windows
®
7 (32-bit, 64-bit)
· Windows
®
8 / 8.1 (32-bit, 64-bit)
For operation of the DC2200, the NI-VISA™ Runtime (V 5.1.1 or later) is required as well. This
NI-VISA™ software is included with the Thorlabs GmbH DC2200 installation package, but can
be downloaded also from National Instruments' website www.ni.com.
To Next Page
Loading...
Need help?
General
