EasyManuals Logo

THORLABS DCU223 SERIES User Manual

THORLABS DCU223 SERIES
420 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #256 background imageLoading...
Page #256 background image
251SDK (Software development Kit)
© 2010 Thorlabs
7.3.84
is_SetExposureTime
USB 2.0
USB 2.0
Syntax
INT is_SetExposureTime (HIDS hCam, double EXP, double* newEXP)
Description
Using is_SetExposureTime(), you can set the exposure time (in milliseconds). Since this value
depends on the sensor timing, the exposure time actually used may slightly deviate from the value
set here. The actual exposure time is returned by the newEXP parameter.
In free-running mode (is_CaptureVideo() ), any modification of the exposure time will only
become effective when the next image but one is captured. In trigger mode (
is_SetExternalTrigger() ), the modification will be applied to the next image.
For minimum and maximum exposure times as well as other sensor-based dependencies, please
refer to Specifications: Sensors chapter.
Newer driver versions sometimes allow an extended value range for the exposure time setting. We
recommend to query the value range every time and set the exposure time explicitly.
The use of the following functions will affect the exposure time:
is_SetPixelClock()
is_SetOptimalCameraTiming()
is_SetFrameRate() (if the new image duration is shorter that the exposure time)
is_SetAOI() (if the image size is changed)
is_SetSubSampling()
is_SetBinning()
Changes made to the window size, the frame rate or the read-out timing (pixel clock frequency)
also affect the defined exposure time. For this reason, you need to call is_SetExposureTime()
again after such changes.
Input Parameters
hCam
Camera handle
EXP
New desired exposure time
For EXP=0.0, the exposure time is 1/frame rate.
IS_GET_EXPOSURE_TIME
Returns the current exposure time in the newEXP
parameter.
IS_GET_DEFAULT_EXPOSURE
Returns the default exposure time.
IS_SET_ENABLE_AUTO_SHUTTER
Enables the auto exposure function.
newEXP
Returns the exposure time actually set.
124
253
402
277
275
259
219
284
231

Table of Contents

Other manuals for THORLABS DCU223 SERIES

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS DCU223 SERIES and is the answer not in the manual?

THORLABS DCU223 SERIES Specifications

General IconGeneral
BrandTHORLABS
ModelDCU223 SERIES
CategorySecurity Camera
LanguageEnglish

Related product manuals