344 DCx camera
© 2010 Thorlabs
The device ID is invalid. Valid IDs start from 1 for
USB cameras.
The board ID is invalid. Valid IDs range from 1
through 255.
A timeout occurred. An image capturing process
could not be terminated within the allowable
period.
One of the submitted parameters is outside the
valid range or is not supported for this sensor or is
not available in this mode.
No memory could be allocated.
The camera is connected to a port which does not
support the USB 2.0 high-speed standard.
A capturing operation is in progress and must be
terminated before you can start another one.
The requested image is not available in the
camera memory or is no longer valid.
The function cannot be used because the camera
is waiting for a trigger signal.
A CRC error correction problem occurred while
reading the settings.
This function has not been enabled yet in this
version.
The camera does not contain any calibration data.
The system is waiting for the kernel driver to
respond.
The camera model used here does not support
this function or setting.
The dialogue was cancelled without a selection so
that no file could be saved.
An internal structure has an incorrect size.
The image memory has an inappropriate size to
store the image in the desired format.
This setting is not available for the currently set
pixel clock frequency.