Page 10
MTN028837-D02
PM5020 Dual-Channel Benchtop Power and Energy Meter Chapter 4 Operating Instructions
3. Select "Analog Output" in the top panel to adjust the settings.
The settings are described in the below chapters for each output port.
4.4.1 AN1/2 Out
The analog output ports AN1 and AN2 on the rear panel for channels 1 and 2, respectively, provide the raw
signal or signal processed in the following way, depending on the configuration set in the touchscreen Set-
tings Menu shown below.
The function of the kind of signal to be exported on the AN1 or AN2 port can be selected as Main Unit,
Base Unit or Raw Signal under "Function":
To Next Page
Loading...
Need help?
General
