EasyManuals Logo

THORLABS WFS Series User Manual

THORLABS WFS Series
157 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #83 background imageLoading...
Page #83 background image
© 2007-2012 Thorlabs GmbH
80 WFS Series
Microlens Array Selection
A Thorlabs WFS Wavefront Sensor can be operated with different Microlens Arrays
(MLAs), see Parts List chapter. Each available MLA is factory calibrated. In order
to supply the correct calibration data to the WFS software you need to select the
physically installed MLA from the pull down list.
You are reminded by the message below to switch the physically installed MLA if a
different MLA than before was chosen.
Attention
Be sure to have the selected MLA physically installed in front of your Wavefront
Sensor!
Otherwise, all measurement data become invalid because wrong calibration
data!
9

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the THORLABS WFS Series and is the answer not in the manual?

THORLABS WFS Series Specifications

General IconGeneral
BrandTHORLABS
ModelWFS Series
CategoryAccessories
LanguageEnglish