SAWMILL ASSEMBLY
Unpacking the Sawmill
3
3-6 15doc110819 SAWMILL ASSEMBLY
3.2 Unpacking the Sawmill
WARNING! Place the sawmill bed on firm and level ground. Fasten
the sawmill to the ground to prevent moving during operation. Failure
to do so may cause the saw head to tip, causing serious injury or
death.
Needed Tools:
- Strap Cutter
- Screwdriver Set
- Socket Wrench Set
- Socket Wrench Extension Bar (Option)
- Flat Wrench Set
- Allen Wrench Set
- Moving equipment (such as a fork-lift truck)
Leave enough room around the sawmill for the operators, sawdust removal, log loading, and board
removal.
See Figure 3-1.
Before unpacking the sawmill, remove all square head wood screws.
WARNING! When unpacking the sawmill saw head, be extremely
careful and keep all persons away. Failure to do so may result in
serious injury or death.
FIG. 3-1
To Next Page