Timbery M120 Series - Horizontal Adjustment of Idle-Side Blade Wheel

To Next Page

To Previous Page

OPERATION Horizontal Adjustment of Idle-Side Blade

OPERATION doc110819 4-6

4.6 Horizontal Adjustment of Idle-Side Blade Wheel

First, adjust the idle-side blade wheel horizontally. To do this, loosen the set nuts on the adjustment

bolts and tilt the blade wheel until it is properly aligned.

See Figure 4-3. The bolts for adjustment of the idle-side blade wheel are shown below.

If the blade is too far out, back the blade onto the wheel by turning the cant control bolt left. If the

blade is too far in, turn the cant control right until the gullet of the blade is the correct distance from

the front edge of the wheel.

FIG. 4-3

Śruba regulacji

pochylenia koła

Cant Control

Bolt