OPERATION Gas Engine Operation (G9, G14)
OPERATION doc110819 4-28
4
4. Cold engine: Close the engine choke by moving the choke lever to position “ON”. Disengage the
tensioner handle (by moving it away from you).
5. Warm engine: Disengage the tensioner handle (by moving it away from you). A warm engine
usually does not require choke on.
6. Pull the engine starter cord slowly until you feel resistance, then pull the cord quickly to start the
engine.
7. Cold engine: When the engine starts, slowly open the choke all the way by moving the choke lever
to the “OFF” position.
8. Press and hold the safety handle (CE sawmills only).
9. Engage the tensioner handle by pushing it toward you as shown below.
See Figure 4-23.
NOTE: Let the engine to idle for about 1-3 minutes (depending on
ambient temperature) to warm up the engine before starting the
sawing operation.
FIG. 4-23
Tensioner Handle
Safety Handle
To Next Page