Maintenance
Maintenance doc110819 5-3
5
5.2 General Maintenance
Daily (every 8 hours of sawmill operation)
Check the engine oil level. (See the Engine Manual.)
Clean the track rollers, mast carriages and track wipers.
After you have finished using the sawmill, lower the saw head all the way down so that the saw
head rests on the stop bolts and the lift cables are not tensioned.
Inspect the sawmill parts for damage.
Open the blade housing cover and brush any sawdust buildup from the housing, cover
and V-belts.
See Figure 5-3.
FIG. 5-3
To Next Page